DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1899UDS1-BD (UDS1 Interface Circuit Pack)
9
Table 9-701. TEST #1214 One-Way Span Test
Error
Code Test
Result Description/ Recommendation
ABORT Internal system error
1. Retry the
test ds1-loop UUCSS one-way-span-test-begin
command at
1-minute intervals a maximum of 5 times.
1005 ABORT One-Way Span Test cannot be executed in the current configuration. To run
this, the TN464F or later suffix UDS1 must be administered for 24-channel
operation. The "Bit Rate" field on the DS1 circuit pack administration form must
be set to "1.544" for 24-channel operation.
1015 ABORT Ports on the UDS1 Interface circuit pack have not be en b usied out to
out-of-service.
1. Enter the busyout board UUCSS command to put all trunks or ports of
the UDS1 Interface circuit pack into the out-of-service state.
2. Retry the command.
1039 ABORT The UDS1 Interface circuit pac k is providing timing for the system. Executing
this test could cause major system disruption.
If the UDS1 Interface circuit pack needs to be tested, set the synchronization
reference to another DS1 Interface circuit pack or to the Tone-Clock circuit
pack via the following command sequenc e:
1. Issue the disable synchronization-switch command.
2. Next, issue the set synchronization UUCSS command.
3. Lastly, issue the enable synchronization-switch command.
1950 ABORT Another loopb ack/span test is already executing on the DS1 board or the
board is in a network requested loopback mode (Line loopb ack or Payload
loopback). The hard ware error log will indic ate whether a Customer Loopb ack
Jack Test, Far CS U Loopback T est , or the On e-Way Span Test i s executing or if
the board is in line loop back or payload loop back mode. Only one
long-duration loopback/span test can b e active at a given time. Thus, if a
loopback/span test is already active, that test must be terminated via the
test
ds1-loop UUCSS end-loopback/span-test
command in order to execute this
test.
Continued on next page