Lucent Technologies Release 7 9-1240PKT-BUS (Packet Bus)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-1240PKT-BUS (Packet Bus)
9
optionally install a Maintenance/Test circuit p ack in order to make use of its
analog trunk and dig ital line test capab ilities, and to enhance the system’s
analog trunk and dig ital line test capab ilities, system’s ability to quic kly
recognize a pac ket bus failure.
Table 9-495. Test #572 Maintenance/Test Circuit Pack
Query Test
Error
Code Test Result Description/ Recommendation
1006 ABORT The packet bus port of the Maintenance/Test circuit pack is out of service.
1. Determine if the port is busied out. If so, release it with the release port
UUCSS04 command. Then retry the test command.
2. If there are alarms active against the packet bus port (MT-PKT), refer to
M/T-PKT Maintenance documentation to reso lve them. Then retry the test
command.
1142 ABORT No Maintenance/Test circuit pack packet bus port is in service in this
port-network.
1. If this port-network is required by configuration g uidelines to have a
Maintenance/Test circuit pack (i.e., it is either a PPN or else an EPN in a
system having both SPE and PNC duplication) either
a. the Maintenance/Test circuit pack for this port-network has failed, and
should be replaced,
b. the Maintenance/Test circuit pack has been b usied out, and should be
released, or
c. there is no Maintenance/Test circuit p ack in this port -network, and one
must be installed.
2. In an EPN of a system without both SPE and PNC duplication, the
Maintenance/Test packet bus Port is not required and may not be present.
If it is present, and is b usied out, or has failed, rele ase or replace the ci rcuit
pack. If there is no Maintenance/Test circuit pack, ignore the results of this
test for this port-network.
2000 ABORT The test timed-out while waiting for an uplink CCMS response from the
Maintenance/Test packet bus port.
1. Re-enter the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, check for p roblems with the Maintenance/Test
packet bus port (look for M/T-PKT in the Error and Alarm Logs).
2059 ABORT The Maintenance/Test packet bus port has reported a hardware failure.
1. Refer to M/T-PKT Maintenance documentation to correct the problem.
2. Re-enter the test command.
Continued on next page