DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-515DIG-LINE (Digital Line)
9
Digital Station Audits Test (#17)
This is a series of six tests that are classified as aud its. The SPE sends messages
to the on-board microp rocessor to perform the following tests. These audits run
only if the station is in-service.
■Switchhook Inquiry Test — This is an up dat e of th e SPE rec ords acc ordi ng
to the circuit pac k’s records. This inquiry is sent al l the way to the voice
terminal.
■Bad Scan Inquiry Test — A message is sent uplink which contains a count
that is generated due to c ertain events relating to the link c onditions. This
can be an indic ation of communications p roblems between the Processor
and Digital Port circuit p ack.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use display port UUCSSpp to determine the station extension or
attendant number of the port. Use status station or status attendant to
determine the service state of the port. If the port is in use, wait until the
port is idle before testing. Attendants are always in use (off-hook) if the
handset is plugged in and the por t is not busied out.
2. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
1392 ABORT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either the display port command
(the display shows that the port is a TTI port) or the list config command
(the display shows a “t” for the port).
2. If either list config or display port indicates that the port is
not
a TTI port,
escalate the problem. If both commands indicate that the port is a TTI port,
the abort is correc t, and no action is ne cessary.
FAIL Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
PASS The message to light all of the station lamps was sent successfully to the port.
1. Observe the station lamps being lit when running the test. If all lamps do
not light, the other Digital Line test results may indicate related problems
that do not allow the lamps to light.
2. Investigate b y using other Digita l Line port tests, and b y examining the
station, wiring, and connections.
Table 9-210. TEST #16 DIG-LINE Station Lamp Updates Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page