Lucent Technologies Release 7 DS1 CO Dial Tone Seizure Test (#314)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-527DIOD-DS1 (DS1 DIOD Trunk)
9
DS1 CO Dial Tone Seizure Test (#314)
DS1 CO Dial Tone Seizure Test checks the trunk’s signaling capability p rovided
by the DS1 Interface circuit pack. The maintenance software initiates the test b y
sending a ‘‘seizure’’ message to the DS1 Interface circuit pac k and expects an
‘‘active’’ reply from the DS1 interface circ uit pack. If the ‘‘active’’ mess age is
received, then the test passes. If n o message is received and the timer expires,
the test is aborted. If the DS1 Interface c ircuit pack send s a ‘‘reorder’’ message
back to maintenance software, the n the test fails.
This test cannot be run on a trunk in any of the following conditions:
a. The trunk direction is administered as an incoming only trunk.
b. The trunk has been seized b y a normal trunk call.
c. The trunk is administered with maintenanc e test disabled.
Table 9-215. TEST #36 Port Audit and Update Test
Error
Code Test Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
FAIL Test failed due to internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
PASS Trunk translation has been updated successfully. The current trunk states kept
in the DS1 Interface circuit pack and switch software are consistent. If the
trunk is busied out, the test will not run but will return PASS. To verify that the
trunk is in-service:
1. Enter the status trunk command to verify that the trunk is in-service. If the
trunk is in-service, no further action is necessary. If the trunk is
out-of-service, continue to step 2.
2. Enter the release trunk command to put the trunk back into in-service.
3. Retry the test command.
Continued on next page