DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1882UDS1-BD (UDS1 Interface Circuit Pack)
9
CSU Equipment Loopback Test (#1210)
This test is destructive.
The CSU Equipment Loopback (ELB) Test causes a loopbac k at the near-edge of
the local Lucent 120A1 CSU Module and tests the connection from the TN464F
DS1 board to the CSU Module (DS1 board ed ge interconnecting cable, and CSU
Module edge). This test will only b e performed if the Luc ent 120A1 CSU Module
is present, administered, and connected to a 1.544 Mb ps TN464F DS1 circuit
pack on the back of the port carrier.
The test is destructive and c an only be initiated by a system tec hnician
demanded
test ds1-loop UUCSS ds1/csu-loop back-tests
command.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
FAIL UDS1 Interface circuit pack failed the DS1 Board Loopback Test.
1. Retry the
test ds1-loop UUCSS ds1/csu-loopback-tests
command.
2. If the BLB test continues to fail, then replace the UDS1 circuit pack.
PASS The BLB test executed successfully. The test pattern was transmitted and
received successfully up to the TN464F DS1 board edge.
0NO
BOARD The test could not relate the internal ID to the port (no board). This could be due
to incorrect translations, no board is inserted, an incorrect board is inserted, or
an insane board is inserted.
1. Ensure that the board translations are correct. Execute the add ds1 UUCSS
command to admini ster the UDS1 interface if it is not alread y administered.
2. If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the board is
shut down. Reseating the b oard will re-initialize the board .
3. If the board was found to be correctly inserted in step 1, then issue the
busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
Table 9-696. TEST #1209 DS1 Board Loopback Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page