Lucent Technologies Release 7 9-86ANL-LINE, ANL-NE-L (8-Port Analog Line)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-86ANL-LINE, ANL-NE-L (8-Port Analog Line)
9
Table 9-35. TEST #36 Station Status and Translation
Audits and Updates Test
Error
Code Test Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1004 ABORT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
extension. Use the status station command to determine the service
state of the port. If the service state indicates that the port is in use,
then the port is unavailable for certain tests. You must wait until the
port is idle before retesting.
2. Retry the command at 1-minute intervals for a maximum of 5 times.
3. If the test continues to abort and the port is not in use, escalate the
problem.
1005 ABORT The test was aborted due to a configuration problem. This code results
under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13,14 and 15
— TN769 vintages 3,4 and 5
1006 ABORT This port has been busied out by command or taken out-of-service by the
failure of the NPE Crosstalk Test.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If
this error is present, then release the port with the release station
extension command and run the test again.
2. Look in the Error Log for Error T ype 1025 (NP E C ross talk Test failed) for
this port. If this error is p resent, then investigate the errors assoc iated
with the NPE Crosstalk Test (#6) first.
3. Make sure that the terminal is connected and in service, and then
retest.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
Continued on next page