DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-109ANN-BD (Announcement Circuit Pack)
9
Table 9-41. TEST #210 140AY Looparound Te st
Error
Code Test
Result Description/Recommendation
1-3 ABORT Response to the test request was not received within the allowable time
period. The error code indicates at which speec h compression rate the test
aborted (1 being the first rate tested, 3 being the last).
1. Retry the command at 1-minute intervals for a maximum of 5 times.
10 ABORT The Playback Speech Memory Array (PSMA) Test (#206) failed on
Announcement Port 1.
90 ABORT The Playback Speech Memory Array (PSMA) Test (#206) failed on
Announcement Port 9.
1. Refer to “ANN-PT”, Test #206.
1000 ABORT System resources required to run this test are not available. This test needs
Announcement Ports 1 and 9 to run. One of the ports may be in use on a
valid call.
If Ports 1 and 9 are not in use, retry the command at 1-minute intervals for a
maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic c onditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic, retry
the command at 1-minute intervals for a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present or some tone
detectors may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals for a
maximum of 5 times.
1007 ABORT The announcement circuit pack thinks that Port 1 or Port 9 is busy.
1024 ABORT Announcement circuit pack bloc ked the test because an announcement
download is in progress. If a download is in p rogress, a status data-module
announcement data extension command should show that the
announcement data port is connected to a data line port that is p art of a
system access port, and the tape drive should be ac tive (to determine the
extension of the announcement data module, use the list data-module
command). See the ‘‘Locked Announc ement Circuit Pack’’ at the end of the
table for Test #209.
1. Wait until download is finished (up to 45 minutes), and then run the test
again.
Continued on next page