DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-80ANL-LINE, ANL-NE-L (8-Port Analog Line)
9
NPE Crosstalk Test (#6)
One or more Network Processing Elements (NPEs) reside on each circ uit pack
with a TDM Bus interface. The NPE controls port connec tivity and gain, and
provides conferencin g functions on a per-p ort basis. The NPE Crosstalk Test
verifies that this port’s NPE channel talks on the selecte d time slot and never
crosses over to time slots reserved for other connec tions. If the NPE is not
working correctly, one-way and noisy connections may be ob served. This test is
usually only part of a port’s Lon g Test Sequence and takes about 20 to 30
seconds to comp lete
Table 9-33. TEST #6 NPE Crosstalk Test
Error
Code Test
Result Description/ Recommendation
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call. This result is also reported for the system’s
Music-on-Hold port when it is off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station’s ext ension.
Enter status station extension to determine the service state of the
port. If the port is in use, it will be unavailable for certain tests. Wait
until the port is idle before retesting.
2. When the port is idle, retry the command at 1-minute intervals up to 5
times.
1001 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due
to TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals for a maximum of 5 times.
2. If the test continues to abort, escalate the problem.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present or some Tone
Detectors may be out-of-ser vice.
1. Resolve TTR-LEV erro rs.
2. Resolve TONE-PT errors.
3. Retry the test at 1-minute intervals for a maximum of 5 times.
Continued on next page