DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-422CO-DS1 (DS1 CO Trunk)
9
Table 9-177. TEST #36 Port Audit and Update Test
Error
Code Test
Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals for a maximum of 5 times.
1000 ABORT System resources required to run this test were not available. The port may be
busy with a valid call.
1. Issue display port UUCSSpp to determine the trunk group/member
number of the port. Use the status trunk command to determine the
service state of the port. If the port is in use, wait until the port is idle before
testing.
2. If the port status is active but the port is not in use (no calls), check the
error log for error type 1025. The port may be locked up.
3. If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
1006 ABORT The DS1 CO trunk is out of service.
1. Use status trunk to verify that the trunk is out of service.
2. If the trunk is out of service, determine why.
3. If it is OK to put the trunk back in service, issue the release trunk
command to put the trunk back in service, and then retry the test.
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT Could not alloc ate the necessary system resource s to run this test.
FAIL Test failed due to internal system error.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
PASS Trunk translation has been updated successfully. The current trunk states kept
in the DS1 Interface circuit pack and switch software are consistent. If the trunk
is busied out, the test will not run but will return PASS. To verif y th at the trun k is
in-service:
1. Enter status trunk to verify that the trunk is in-service. If the trunk is
in-service, no further ac tion is necessary. If the trunk is out-of-serv ice.
2. Enter release trunk to put the trunk back into in-service.
3. Retry the test command.