Lucent Technologies Release 7 9-91ANL-LINE, ANL-NE-L (8-Port Analog Line)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-91ANL-LINE, ANL-NE-L (8-Port Analog Line)
9
1005 ABORT The test was aborted due to a configuration problem. This code will result
under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13,14 and 15
— TN769 vintages 3,4 and 5
1018 ABORT Test disabled via administration. The default for the Test? field on the is y;
thus, you may want to determine why this field has been set to “n” on this
station (this may be due to the ringing application test 48, which can be
customer or terminal disturbing).
1. To enable the test for a particular station, enter change station
extension and set the ‘Test?’ field on the ‘Station Form’ to ‘y.’
1392 ABORT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either the display port command
(the display shows that the port is a TTI port) or the list config
command (the display shows a t for the port).
2. If either list config or display port indicate that the port is
not a TTI
port, escalate the problem. If both commands indic ate that the port is
a TTI port, the abort is correct for the test, and no action is necessary.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available. Either a
system allocation to get information about the port or to put the port into a
service state failed or the attempt to put the port in connection with a tone
source failed (this could be a tone-clock p roblem). The tone-clock and
tone detectors could be having a communic ation problem, for example,
the companding modes could b e out of synchronization.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
Table 9-36. TEST #47 Loop Around and Conference Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page