DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1202PGATE-BD (Packet Gateway Circuit Pack)
9
Circuit Pack Restart Test (#252)
This test is destructive.
This test is used to reset the circuit pac k. This test is not part of either short or
long demand test seq uence and is executed only on detection of PPCPU errors.
The circuit pack is reset via th e SAKI Sanity Test (#53).
The SAKI Sanity Test resets the circuit pac k. This test fails if the circuit pack d oes
not return to a sane state after being reset.
LANBIC Receive Parity Error Counter Test (#595)
The test reads and clears the LANBIC Receive Parity Error Counter on the Packet
Gateway circuit pac k. This counter is incremented by the c ircuit pack when it
detects a parity error with a rec eived frame from the packet b us.
Table 9-478. Test #252 Circuit Pack Restart Test
Error
Code Test
Result Description/ Recommendation
None ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack.
2. Execute command again.
2100 ABORT Coul d not allocate the neces sary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
1 FAIL The circuit pack failed to reset.
1. Execute command again.
2. If the problem persists, then pull out and reinsert the circuit pack.
3. If the problem persists, replace the circuit pac k.
2 FAIL The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, then pull out and reinsert the circuit pack.
3. If the problem persists, replace the circuit pac k.
PASS The circuit pack initializes correctly.
1. Run the short test sequence.
Continued on next page