DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-974ISDN-TRK (DS1 ISDN Trunk)
9
1019 ABORT Another Test call is in progress.
1. Issue the list isdn-testcall command to locate the test call.
2. Issue the status isdn-testcall command to find out the duration and start
time of the test call.
3. Issue the clear isdn-testcall command to stop the test call from running.
4. If time and duration indicate that the test call should have stopped, and
the clear isdn-testcall command does not work, refer to M/T-DIG
(Maintenance/Test Digital Port) for recommended maintenance strategy.
1020 ABORT There is a problem with the DS1 Interface Circuit Pack.
1. Refer to “DS1-BD or UDS1-BD”.
1024 ABORT (M/T-DIG) Maintenance/Test Digital Port in use.
1. Wait until yellow and green LED s are turned off on the M/T-BD
(Maintenance/Test circuit pack).
2. Retry test. If problem persists, refer to M/T-DIG (Maintenance/Test Digital
Port).
1113 ABORT The signaling link has failed. Therefore, the system cannot send any messages
on behalf of this trunk.
1. Check the results of Test #255 (Signaling Link State Check Test).
1116 ABORT The switch could not appropriately change the ISDN service state.
1. Determine if a call is active on this DS1 ISDN Trunk (use the status trunk
group#/member# command). If so, proceed as for Error Code 1119.
2. If not, check the Error and Alarm Logs for problems with this ISDN-TRK
(DS1 ISDN Trunk) MO.
1117 ABORT ISDN Service message is already ou tstanding.
1. Wait 2 minutes. Then try again.
1118 ABORT Far-end of ISDN trunk is not administered.
1. Check the administration of the far-end ISDN trunk.
2. Issue the status trunk group#/member# command.
3. Try the test again.
1119 ABORT The test call was aborted due to a normal call attempt on this trunk. NOTE: The
test call will only be performed if the trunk is idle.
1. Either wait for the normal call to terminate normally, or force it to be
dropped by using the busyout trunk trunk group/trunk member
command to busyout the DS1 ISDN Trunk. When the trunk is idle, retry the
test.
Table 9-375. TEST #258 ISDN Test Call — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page