DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-973ISDN-TRK (DS1 ISDN Trunk)
9
■status isdn-testcall group#/member#
This command displays the progress of the outgoing test call by rep orting
bit and bloc k error rates of the tested B-Channel.
■clear isdn-testcall group#/member#
This command terminates an outgoing test call already in p rogress.
Measurements already collected are not cleared until the next test call
begins.
A PASS of the asynchronous test indicates only that the test call was successfully
established. Use the status and list commands to g et the results of the test.
NOTE:
Before attempting to make an ISDN-PRI test call to the public network (that
is, the network is the far-end), make sure that test call servic e is provisioned
by the network. The user must subscrib e to Test Type 108 service and have
the correct far-end test c all number administered on the trunk group form
for the call to be allowed.
Table 9-375. TEST #258 ISDN Test Call
Error
Code Test
Result Description/ Recommendation
4 ABORT There is a problem with the Signaling Channel.
1. Consult the procedures for the ISDN-PRI Signaling Group (ISDN-SGRP).
Further information may also be ob tained by c onsulting the proc edures for
the ISDN-PRI Signaling Channel (ISDN-LNK).
8 ABORT There is a problem with the DS1 interface circuit pack.
1. Consult the procedures for the appropriate DS1 interface circ uit pack
(DS1-BD or UDS1-BD).
1004 ABORT B channel in use.
1. Determine if a call is active on this DS1 ISDN Trunk via the status trunk
group#/member# command.
2. When the service state indicates in-servic e/idle, retry the test.
1005 ABORT Bad Configuration (such as no Maintenance/Test circuit pac k)
1. Make sure the Maintenance/Test Circuit Pack is inserted.
2. Repeat the test.
1018 ABORT Test call is disabled.
1. Enable Maintenance on the Trunk Group form.
Continued on next page