DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-869FIBER-LK (Fiber Link)
9
140 FAIL The endpoint 1 SNI is physically connected to a DS1 CONV but is not
administered to be connected to a DS1 CONV (list fiber-link can be used to
display fiber lin k endpoints). Either add the DS1 converter compl ex to the fiber
that this SNI is associated with by:
1. Check for the fiber that this SNI is an endpoint of by checking list
fiber-link.
2. Remove fiber-link for the fiber that this SNI is an endpoint of.
3. Add the fiber bac k via add fiber-link and this time administer the DS1
converter complex also. Or, remove the DS1 CONV connection and
connect the SNI directly to its administered fiber endpoint by entering list
fiber-link and verifying that the fiber optic cable and metallic cable
connections are installed as administered.
202 FAIL The SNI circuit pack (endpoint 2) cannot communicate with the equipp ed SNI
in slot 2 (list fiber-link can be used to display fiber link endpoints).
1. Perform the ‘‘Fiber Fault Isolation Procedure’’. This shoul d resolve mul tiple
SNI-PEER err ors.
2. If the SNI being tested has SNI-PEER Error Type 1, replace the SNI being
tested. Replacing an SNI may be service interrupting. Refer to the SNI-BD
secti on for the pr oced ure fo r repl acing an SNI . To view SNI -PEER error s,
use the display errors command with category PNC-PEER. Retry the
command.
3. If the SNI being tested still has SNI-PEER Error Type 1, replace the SNI in
slot 2.
203 FAIL The SNI circuit pack (endpoint 2) cannot communicate with the equipp ed SNI
in slot 3 (list fiber-link can be used to display fiber link endpoints).
1. Perform the ‘‘Fiber Fault Isolation Procedure’’. This shoul d resolve mul tiple
SNI-PEER err ors.
2. If the SNI being tested has SNI-PEER Error Type 257, replace the SNI being
tested. Replacing an SNI may be service interrupting. Refer to the SNI-BD
secti on for the pr oced ure fo r repl acing an SNI . To view SNI -PEER error s,
use the display errors command with category PNC-PEER. Retry the
command.
3. If the SNI being test ed sti ll has SNI-PEER Erro r Type 25 7, rep lace the SNI i n
slot 3.
Table 9-333. TEST #759 Configuration Audit — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page