DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1642TAPE
9
1339 ABORT Could not run the test on the Standby SPE—Handshake down.
1. Refer to the documentation for STBY-SPE maintenance.
2. When the standby is restored to service (use status spe to determine
state of standby) retry the command.
1347 ABORT Could not run the test on the Standby SPE—Refresh not complete.
1. When the standby is restored to service (use status spe), retry the
command.
1350 ABORT Could not run the test on the Standby SPE—Shadowing not enabled.
1. When standby is restored to service (use status spe), retry command.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
5102 ABORT Could not allocate the Mass Storage System to run this test
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
2. If the test continues to abort, verify that the daily translation-save
operation is not in progress (issue the display system-parameters
maintenance command to display the time for scheduled maintenance
and the "y/n" option for saving translation daily).
NO
BOARD The tape has been placed in the "uninstalled" state.
1. Verify that a tape cartrid ge is installed and not wr ite-protected and tha t the
tape drive is fully inserted and powered up.
2. Attempt a demand reset of the tape.
1FAIL The tape could not be accessed, the chec ksum on the data written did not
match the checksum in memory or the data read did not match the data
written.
1. Verify that a tape cartrid ge is installed and not write- p rotected.
2. If a non-write-protected tape was inserted, remove it and clean the Tape
Heads.
3. If the test continues to fail, replace the Tape Cartridge. Wait for the
retension pass to complete. If the test succeeds, issue the backup disk
command.
4. If the test continues to fail, replace the Tape circuit pack.
5. If the test continues to fail, replace the MSSNET circuit pack.
Table 9-618. TEST #810 Tape Write-Read Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page