DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1224PGATE-PT (Packet Gateway Port)
9
Packet Gateway Port Remote Loop-around Test (#611)
This test is destructive.
This test checks the integrity of c abling and d evices external to the Packet
Gateway port hardware. Packet Gateway firmware exec utes this test on demand
by sending a test frame whic h is looped bac k to the Packet Gateway by a
loop-around that has been externally activated or installed at one of several
points in the external connec tivity (see loopbacks A, B and C in the figure below).
The test passes when the sent and received test frames are identical. The test
fails if the sent and received test frames do not match, or if no test frame is
received prior to a time out.
If you suspect a prob lem in cabling or exter nal devices, then repeat this test at
points that are progressively further from the PGATE port until either a failure
point is identified or the integ rity of the entire path is verified. Cer tain site
configurations may require teamwo rk with those who maintain the off-site
transmission facilities.
FAIL The Packet Gateway circuit pack has detected a failure in the execution of the
test.
1. If the test fails repeatedly, attempt to reset the circuit pack if the other ports
on the board are not in use (Yellow LED is off). Reset the circuit pack by
issuing the busyout board UUCSS and the reset board UUCSS
commands.
2. If the test fails again, replace the circuit pack.
PASS The circuitry of the port tested is functioning properly.
Table 9-488. TEST #610 Packet Gateway Port Local Loop-Around Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page