DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-601DS1-BD (DS1 Interface Circuit Pack)
9
When the DS1 Interface circuit pac k detects a slip c ondition, the circuit p ack will
increase the on-board slip counter by 1. A SLIP-COUNT message is
spontaneously sent to the system software after the c ounter reaches a threshold
(for example, 88). When the maintenance software receiv es the SLIP-COUNT
message, the Slip Alarm Inquir y Test is initiated to query the slip counters on D S1
Interface circuit p ack and total the slip c ounts in the maintenance software.
If the count of slips is over the threshold, a Minor alarm is rais ed against the DS1
Interface circuit p ack. All trunks of the DS1 Interface circ uit pack are still in the
in-service state. If the DS1 Interface circ uit pack is used to sup ply the system
synchronization source, the MINOR alarm will initiate a sync hronization source
switch. See “TDM-BUS” and "SYNC (Synchronization)" for details.
Table 9-243. TEST #144 Slip Alarm Inquiry Test
Error
Code Test Result Description/ Recommendation
ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test was not received within the allowable time period. This
may be due to hyperactivity. Error type 1538 in the error log indicates
hyperactivity. The hyperactive circuit pack is out of service and one or more
of the following symptoms may be exhibited.
1. The DS1-BD tests (such as test 138 and test 139) are aborting with error
code 2000.
2. The tests run on the ports o f this circuit pac k are returning a no board
result.
3. A busyout or a release command has no affect on the test results.
4. A list config command shows that the circuit pack and the ports are
properly installed .
NOTE:
When hyperactivity occurs, the circuit pack is isolated from the
system, and all of the trunks for this circuit pack are placed into the
out of service state. The system will try to restore the circuit pack
within 15 minutes. When no faults are detected for 15 minutes, the
DS1 interface circuit pack is restored to normal operation. All of the
trunks for the DS1 interface circuit pack are then returned to the in
service state. Hyperactivity is often caused by the associated facility.
In such a case, faults (such as slips, misframes, or blue alarms) would
be entered in the error log. In addition, many hardware errors would
be logged against the associated trunk ci rc uits. If the facility is OK
and the error occurs again after 15 minutes, replace the circuit pack.
Continued on next page