DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1951XXX-BD (Common Port Circuit Pack)
9
Neon Test (#220)
This test checks the voltage requ ired to light the neon lamp on an an alog
terminal. A relay connects a 150V DC source from the backplane of the c ircuit
pack onto the voltage b us, and another relay connects a 2K shunt from the b us to
ground. Current in the line is then monitored to determine if the voltage is
present. The neon test runs only for TN746 and TN769 Analog circ uit packs. If
the circuit pac k is not a TN746 or TN769, the test will return PASS, but the test is
not actually run.
Table 9-725. TEST #220 Neon Test
Error
Code Test
Result Description/ Recommendation
ABORT Cannot get the list of translated ports on the circuit pack.
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the station
extension. Use the status station command to determine the servic e state
of the port. If the service state indicates that the port is in use, then the port
is unavailable for certain tests. Refer to the status commands described in
Chapter 8 for a full description of all possible states.) You must wait until the
port is idle before retesting.
2. Retry the command at 1-minute intervals a maximum of 5 times.
1008 ABORT Could not allocate a ring ing circuit. Either all t he ringing circ uits are in use, or
the ringing gen erator is defective or is not wired correctly.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Error Log. If
an ABORT 1008 occurs for this test on other circuit packs as well, then the
ringing generator may be defective or is not wired c o rrec tly (see errors for
RING-GEN). If it does not occur on port test 48 for ANL-16-L, then all four
ring phases are in use.
2000 ABORT Response to the request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Could not allocate the necessary system resources to run this test. Internal
system error.
1. If Error Type 1538 is present in the Error Log, follow the recommended
maintenance strategy.
Continued on next page