DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-1934WAE-PORT (Wideband Access Endpoint Port)

9
Conference Circuit Test (#7)
The Conference Circuit Test verifies that the NPE channel for the port being tested can correc tly perform the conferenc ing function. The NPE is instructed to listen to several different tones and c onference the tones together. The resulting signal is then measured by a Tone Detector port. If the le vel of the tone is within a certain range, the test p asses
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The NPE of the tested port was found to be transmitting in error. This causes
noisy and unreliable c onnections.
1. Replace the circuit pack.
PASS The port is correctly using its allocated time slots.
1. Investigate user-reported troubles on this port using other por t tests and
by examining the terminal adapter or external wiring.
Table 9-717. TEST #7 Conference Circuit Test
Error
Code Test
Result Description/ Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are n ot ava ilable. T he port may be in
use on a valid call. Use the status access-endpoint extension command to
determine when the port is available for testing.
1004 ABORT The port has been seized by a user for a valid call. Use the status
access-endpoint extension command to determine when the port is available
for testing. The port is availa b le when it is in the in-service/idle state.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Table 9-716. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page