DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1115M/T-DIG (Maintenance/Test Digital Port)
9
1004 ABORT The port was seized by a val id ISDN-PRI Test Call. Use the list isdn-testcall
command to determine which call is using the port (from the M/T Port
column). Either wait for the test call to complete (as indicated in the Start
Time and Duration fields of the above display), or abort the test call with the
clear isdn-testcall grp/mem comm and, where grp/m em is determined from
the B-channel field of the above display.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort and the port is not in use, escalate the
problem.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available.
1. Retry the test at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, escalate the problem.
7 FAIL Conference test failed on the primary information channel. In most cases, the
user may not notice a disruption in service.
1. Run the circuit pack tests to check the Tone Generator circuit pack and
the Tone Detector circuit pack via the test board UUCSS command.
2. Resolve any problems that are detected on the Tone Generator circuit
pack or Tone Detector circuit pack.
3. If the Tone Generator and Tone Detector circuit packs are functioning
properly, and the test still fails, replace the Maintenance/Test circuit
pack.
14 FAIL The primary information channel is not transmitting properly. User impact
may range from nothing to not being able to use this port.
1. Run the circuit pack tests to check the Tone Generator circuit pack and
the Tone Detector circuit pack using test board UUCSS.
2. Resolve any problems that are detected on the Tone Generator circuit
pack or Tone Detector circuit pack.
3. If the Tone Generator and Tone Detector circuit packs are functioning
properly, and the test still fails, replace the Maintenance/Test Circuit
Pack.
PASS The Maintenance/Test Digital Port digital trunk testing capability is operating
correctly.
Table 9-442. TEST #13 Digital Port Loop Around Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page