DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-1118M/T-DIG (Maintenance/Test Digital Port)

9
Hook State Inquiry (#566)

This test ensures that the Maintenance/Test Digital Port maintenance software

and call proces sing agree on the on-/off-hook status of the Maintenanc e/Test

Digital Port.

1138 ABORT This test does not run on port 3 of the Maintenance/Test circuit pack. This
test will only run on port 2. Look at the results of the Digital Port Sanity Test
for port 2.
1. Run the command again for port 2 via the test port UUCSS02 or test
port UUCSS02 l command.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available.
2500 ABORT An internal operation failed; the test could not be completed.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, escalate the problem.
50 FAIL The switch was unable to communicate with the port circ uitry used for
digital trunk testing.
100 FAIL Data was not sent from port 2 to port 3 successfully in asynchronous mode.
101 FAIL Data was not sent from port 3 to port 2 successfully in asynchronous mode.
102 FAIL Data was not sent from port 2 to port 3 successfully in synchronous mode.
103 FAIL Data was not sent from port 3 to port 2 successfully in synchronous mode.
1. Reset the circuit pack via the busy-out board UUCSS, reset board
UUCSS, release board UUCSS command sequence.
2. Test the port again via the test port UUCSS02 l command.
3. If the test fails again, replace the circuit pac k.
PASS The Maintenance/Test Digital Port di gital trunk testing capability is o perating
correctly.
Table 9-444. TEST #565 Digital Port Sanity Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page