DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1614SYSAM (Circuit Pack)
9
Table 9-610. TEST #915 SYSAM G3-MT Looparound Test
Error
Code Test
Result Description/ Recommendation
100 ABORT The requested test did not complete within the allowable time period.
1. Retry the command.
1000 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals, a maximum of 5 times.
1318
1335
2029
2033
2500
ABORT Internal system error
1. Retry the command.
1338 ABORT The test i s not al lowed to run w ith a p lanned SPE inter chang e in p rogre ss.
This may be caused by a planned interchange initiated automatically during
24 hour scheduled testing.
1. Wait 3 minutes and retry the command.
1339 ABORT The test could not run on the standby SYSAM circuit pack in the standby SPE
carrier because the standby SPE is unavailable.
1. Refer to the STBY-SPE maintenance documentation for information on
why a standby SPE may be unavailable, and related repair ac tions. The
screen for the status spe command should indicate that handshake is
down. This may be caused by a variety of reasons such as the
SPE-SELECT swi tches on the DU PINT cir cuit p acks being set to the
position of the active SPE, a failure of the DUPINT circuit pack, or loss of
power on the standby SPE. The SPE selected field on the status spe
screen displays spe a or spe b if both SPE-SEL ECT switc hes are in the
a or b positions, respectively.
2000 ABORT Response to the test request was not received within the allowable time
period. If the system is eq uipped with the Hig h Reliability or Critical Reliab ility
Config urati on and if the SYSA M circ uit p ack is on the st andb y SPE, this abort
code may indicate that the standby SPE is not responding to the handshake
message. If this is the case, the standby SPE maintenance software may take
up to two minutes to indicate that handshake communication with the
standby SPE is down. The ABORT code then changes to 1339 (standby SPE
unavailable).
1. Retry the command at 1-minute intervals, a maximum of 3 times.
2334 ABORT The hardware mailbox on the standby Duplication Interface b oard is not
ready to receive messag es.
1. Retry the command at 1-minute intervals, a maximum of 5 times.
Continued on next page