DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-130ASAI-EPT
9
k. The switch software logs certain ASAI cause values. The cause value is
determined from the following formulas:
— If th e error type is greater than 3712, then the ASAI cause value is
equal to the error type minus 3712. The switc h sent this value to the
adjunct.
— If th e error type is less than 3712, then the ASAI cause value is
equal to the error type minus 3584. The adjunc t sent this value to
the switch.
Table 9-51 contains a description of the var ious ASAI cause values and
recommended system tec hnician actions associated with the cause value.
The
ISDN-BRI Specification
contains further information.
l. The switch software logs certain ASAI cause values. The cause value is
determined from the following formula:
— If th e error type is greater than 3968, then the ASAI cause value is
equal to the error type minus 3968. The switc h sent this value to the
endpoint.
— If th e error type is less than 3968, then the ASAI cause c ode is
equal to the error type minus 3840. The endp oint sent this value to
the switch.
Table 9-51. ASAI Cause Values
Code Explanation Recommendation
0 Unrecognized
ASAI Protocol
Operation.
Requested ASAI protocol is not implemented by switch or adjunct. Aux
Data field of error log entry contains protocol identifier for
unrecognized operation.
1. Consult switch and adjunct d ocumentation to dete rmine which set
of operations is supp orted by switc h and the adjunc t . Turning off
adjunct operations not implemented by the switch may resolve the
problem.
34 No circuit or
channel
available
A resource on the switc h is unavailable for a ca ll. For BRI endpoints,
this cause value is not logged. For ASAI, this condition means that
there are no available trunks for an outgoing call request.
1. Verify that the adjunct is administered to support the trunk
capabilities of the switch.
2. Investigate t runk group status by i ssuing the status trunk
command from the SAT or by requesting trunk group query(ies)
from the adjunct.
3. Perform trunk diagnostic procedures outlined in this manual.
40 Resources not
available. No available internal resources to service switch or adjunct req uest.
Exceeds system transaction capacity for adjunct or switch.
1. May require re-engineering of adjunct services.
Continued on next page