DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-691DS1 CONV-BD
9
Failure Audit (#949)
This test is non-destructive.
This test queries the DS1 CONV circuit pack for any existing circuit pack or
facility failures and any unackno wledged cleared failure messages for auditing
purposes. Upon rec eiving the query request, DS1 CONV firmware sends failure
reports to the maintenance software for every error in its failure d atabase.
This test operates on both maintenance ob jects DS1C-BD and DS1-FAC. Error
counts of both maintenance o bjects (DS1C-BD and DS1-FAC) that are displayed
in the error log will be incremented when this test is executed. This test is also
executed internally b y the maintenance software when an alarm is resolved
Table 9-267. TEST #795 Board Options Audit
Error
Code Test
Result Description/ Recommendation
105 ABORT The neighbor DS1 CONV circuit pack at the other end of the DS1 CONV
Complex is not accessible (only applies to TN574 boards with vintage less
than 7).
1. Retry the command at 1-minute intervals a maximum of 3 times.
2. The link to the other end of the DS1 CONV Complex may be down. Enter
display errors and follow the associated repair procedures for any
DS1C-BD and DS1-FAC errors.
2000 ABORT Timed out while waiting for a response from the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
2300 ABORT The downlink message necessary to run this test could not be sent.
2301 ABORT The timer could not be set before sending the downlink message necessary to
run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2316 ABORT Fiber link is not administered. Administer the DS1 CONV fiber link via the add
fiber-link command.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 3 times.
PASS The options are sent to the circuit pac k.
0NO
BOARD The system software found no board.
1. Reset the board.
2. Remotely retry the command.
Continued on next page