Lucent Technologies Release 7 9-1043MET-LINE (MET Line)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-1043MET-LINE (MET Line)
9
1001 ABORT Sys tem resources required to run this test are not available. This could be due
to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The syste m could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic, repeat
test at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present or some Tone Detectors
may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals a maximum of
5 times.
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the station
extension of the port. Use the status station command to determine the
service state of the por t. If the port is in use, wait until the p ort is idle
before testing.
2. Retry the command at 1-minute intervals a maximum of 5 times.
1018 ABORT Test disabled via administration. This only applies to analog stations. The
default for this field is ‘y,’ so you may want to determine why it has been turned
off on this station.
1. To enable the test for the particular analog station being tested, enter the
change station extension command and change the 'Test' field on the
'Station' form from 'n' to 'y.'
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2020 ABORT The test did not run due to an already existing error on the specific port or a
more general circuit pack error.
1. Examine Error Log for existing errors ag ainst this port or the circ uit pack
and attempt to diagnose the already existing error.
2100 ABORT Sys tem resources required to run this test are not available. This could be due
to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Table 9-413. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page