DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1350PROCR (RISC Processor Circuit Pack)
9
Table 9-530. TEST #897 Processor BOOTPROM Checksum Test
Error
Code Test
Result Description/ Recommendation
100 ABORT The requested test did not complete within the allowable time period.
1. Retry the command.
1022
1335
2500
ABORT Internal system error
1. Retry the command.
1338 AB ORT The test is not allowed to run since a p lanned SPE interchange is in progr ess.
This may be caused by a planned interchange initiated automatically during
24 hour scheduled testing.
1. Wait 3 minutes and retry the command.
1339 ABORT The test could not run on the standby Processor circ uit pack in the standby
SPE carri er bec ause th e stand by SPE is un availab le.
1. Refer to the STBY-S P E maintenance documentation for information on why
a standby SPE may be unavailable and what repair actions should be
taken. The screen for the status spe command should indicate that
handshake is down. This may be caused by a variety of reasons such as
the SPE-SELECT switches on the DUPINT circuit packs being set to the
position of the active SPE, a failure of the DUPINT circuit pack, or loss of
power on the st andby SPE. The
SPE Select ed
field on the status spe
screen will display
spe a
or
spe b
if bot h SPE-SELECT swi tches a re in the
a or b positions, resp ectively.
2000 ABORT Response to the test request was not received within the allowable time
period. If the system is equipped with the High Reliability or Critical Reliability
Configuration and if the Processor circuit pac k is on the standby SPE, this
abort code may indicate that the standby SPE is not responding to the
hands hake me ssage. If this i s the ca se, the s tandb y SPE maint enance
software may take up to two minutes to indicate that handshake
communication with the s tandby SPE is down. The ABORT code will then
change to 1339 (stand by SPE unavailable).
1. Retry the command at 1-minute intervals, a maximum of 3 times.
2334 ABORT The hardware mail on the standby Duplic ation Interface board is not ready to
receive messages.
1. Retry the command at 1-minute intervals, a maximum of 5 times.
FAIL The computed checksum did not match the BOOTPROM checksum. The
system may not continue to op erate correctly. The system may fail at some
future date when the corrupted area the bootstrap BOOTPROM is accessed.
1. Replace the Processor circuit pack. To replace the Processor circuit pack,
refer to
Repla c ing SPE C ircuit Packs
in Chapter 5, ‘‘Alarms, Errors, and
Troubleshooting’’.