DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-19ADX8D-PT (AUDIX Digital Port)
9
Table 9-7. TEST #9 NPE Crosstalk Test
Error
Code Test
Result Description/Recommendation
1 ABORT During testing of the primary information channel, system resources may
not have been available. Also, the port may have been busy during the
test.
1. Check the port status.
2. Use the display port UUCSSpp command to deter mine the voice port
extension of the port. Use the status station command to determine
the service state of the po rt. If the service state indic ates that the port
is in use, you must wait until the port is idle.
3. Retry the command at 1-minute intervals for a maximum of 5 times.
2 ABORT System resources may not have be en available, or the port may have be en
busy during the test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be in use.
1. Use the display port UUCSSpp command to deter mine the voice port
extension of the port. Use the status station command to determine
the service state of the po rt. If the service state indic ates that the port
is in use, you must wait until the port is idle before retesting.
2. Retry the command at 1-minute intervals for a maximum of 5 times.
1001 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due
to TDM-BUS errors.
1. If system has no TDM-BUS errors, and if it is not handling heavy traffic,
retry the command at 1-minute intervals for a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present, or some Tone
Detectors may be out-of-ser vice.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT err o rs.
3. Retry the command at 1-minute intervals for a maximum of 5 times.
1004 ABORT The port was put in use during the test. The test has been aborted.
1. Use the display port UUCSSpp command to deter mine the voice port
extension of the port. Use the status station command to determine
the service state of the po rt. If the port is in use, wait until t he port is
idle before testing.
Continued on next page