Lucent Technologies Release 7 9-1844UDS1-BD (UDS1 Interface Circuit Pack)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-1844UDS1-BD (UDS1 Interface Circuit Pack)
9
Table 9-686. TEST #135 Internal Looparound Test
Error
Code Test Result Description/ Recommendation
1002 ABORT The system could not allocate time slots for the test. The system ma y be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS e rrors.
1. If system has no TDM-BUS errors and is not handling heavy traffic, repeat
test at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present or some Tone Detectors
may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the reset board command at 1-minute
intervals a maximum of 5 times.
1004 ABORT Received an incoming call on a port of the UDS1 circuit pack during the test.
1. Enter the busyout board UUCSS command to put all trunks or ports of the
UDS1 Interface circuit pack to out-of-service stat e.
2. Retry the reset board command at 1-minute intervals a maximum of 5
times.
1015 ABORT Ports on the UDS1 Interface circuit pack have not been busied out to
out-of-service.
1. Enter the busyout board UUCSS command to put all trunks or ports of the
UDS1 Interface circuit pack into the out-of-service state.
2. Retry the reset board command.
1039 ABORT The UDS1 Interface circuit pack is providing timing for the system. Therefore, it
cannot be reset without major system disruption.
If the UDS1 Interface circuit pack needs to be tested, set the synchronization
reference to another UDS1 Interface circuit pack or to the Tone-Clock circuit
pack via the following command sequenc e:
1. Issue the disable synchronization-switch command.
2. Next, issue the set synchronization UUCSS command.
3. Lastly, issue the enable synchronization-switch command.
2000 ABORT Response to the test r equest was not r eceived within the allowable time period.
If Error Type 1538 is present in the Error Log, follow the maintenance strategy
recommended for this error type.
2012 ABORT Internal system error
1. Retry the reset board command at 1-minute intervals a maximum of 5
times.
Continued on next page