DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1659TAPE
9
126 Type of device is invalid for
opcode
requested.
201 An unexpected interrupt code wa s returned from the SBICC. This represents a p rotocol
error that could be the result of the HA or the target device. The device may not b e present.
251 SBICC timed out. This could be the fault of the HA or target device. The HA will attempt to
reset the SBICC.
301 DMAC error. This could be the fault of the HA or the SCSI target device.
351 DMAC timed out. This could be the fault of the HA or the SCSI target device. The HA will
attempt to reset the SBICC.
401 Could not save announcements or program update file.
408 Could not read translation from the Disk and Tape as part of system initialization.
409 Could not apply program update file.
422 Could not save translations.
501 A non-critical diagnostic test failed on the Host Adapter. This includes the USART chip test
and the LED tests.
511 A diagnostic test requiring bus ma st ership failed. This happ ens only as the result of an
MSS_DIAG command. This could be the fault of the HA or the system. Therefore t he board
does not put itself in held reset state. Rather, the error is reported and counters are
incremented.
521 The HA looparound test requiring bus mastership failed. This happens only as the result of
an MSS_LOOPAROUND command. This could be the fault of the HA or the system.
Therefore the board does not put itself in held reset state. Rather, the error is reported and
counters are incremented.
531 Target device SEND DIAGNOSTICS self-test indicated a hardware error. This ind icates
that there are problems with the controller or the device, and it should be taken out of
service. This error will not occ ur if other errors (e.g. SBICC) p revent the SEND
DIAGNOSTICS command from running.
551 The target device internal looparound failed due to data c orruption. Other errors (SBICC,
SCSI check condition) would cause a different error code to be reported. This failure
demonstrates that the target may potentially corrupt data and it should be taken out of
service.
552 The target device external looparound failed due to data corrup tion. Other errors (SBICC,
SCSI check condition) cause a different error code to be reported. This failure
demonstrates that the target may potentially corrupt data. However, the HA does not take
the device out of service as a result of this error. This test is only run following the target
device internal looparound which detects ac tual problems with the target device. This
failure implicates the HA bus interface or a system problem.
561 When the MSS_RESET command was issued for a device, it was found not to be present.
562 When the MSS_RESET command was issued for a device, the NQUIRY command failed.
Table 9-624. MSS Error Actions — Continued
Code Description
Continued on next page