DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-888GPTD-PT (General Purpose Tone Detector Port)
9
Technician-Demand T e sts: Descri ptions and Err or
Codes
Always investigate tests in the order p resented below when inspe cting errors in
the system. By clearing error c odes associated with the
Tone Detection Verification Test,
for example, you may also clear errors g enerated from other
tests in the testing sequenc e.
Tone Detection Verification Test (#42)
This test verifies that the call progress tones d etection and the tone level
measurement capabilities of th e GPTD port are functioning properly.
Order of Investigation Short Test
Sequence Long Test
Sequence D/ND1
1. D = Destructive; ND = Nondestruc tive
Tone Detection Verification Test (#42) X X ND
Tone Detector Audit/Update Test (#43) X X ND
Table 9-338. TEST #42 Tone Detection Verification Test
Error
Code Test
Result Description/ Recommendation
ABORT The system was not able to allocate all the resources needed for this test or
there was an Internal system error.
1 ABORT The system could not allocate all the resources needed to test the call progress
tones.
1001 ABORT The system was unable to put the GPTD port in the appropriate mode to test it.
1002 ABORT The system could not allocate time slots for the test connection. This can
happen when the system is heavily loaded. If the system is not heavily loaded,
then test the TDM-BUS via the test tdm [1|2] command.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page