DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1030MEM-BD (32MB Memory Circuit Pack)
9
Table 9-406. TEST #902 Memory Single/Multiple Bit Error Audit
Error
Code Test
Result Description/ Recommendation
100 ABORT The requested test did not complete within the allowable time period.
1. Retry the command.
1022
1335
2500
ABORT Internal system error.
1. Retry the command.
1338 AB ORT The test is not allowed to run since a p lanned SPE interchange is in progr ess.
This may be caused b y a planned interchan ge initiated automaticall y during 24
hour scheduled testing.
1. Wait 3 minutes and retry the command.
1339 ABORT The test could not run on the standby Memory circuit p ack in the standby SPE
carrier because the standby SPE is unavailable.
1. Refe r to the s ection on "STBY-SPE (Sta ndby SPE M aintena nce)"
procedures for information on why a standby SPE may be unavailable and
what repair actions should be taken. The status spe screen should
indicate that handshake is down. This may be caused by a variety of
reasons such as the SPE-SELECT switches on the DUPINT circuit packs
being set to the position of the active SPE, a failure of the DUPINT circuit
pack, or loss of power on the standby SPE. The
SPE Select ed fiel d
on the
status spe-standby screen will d isplay
spe a
or
spe b
if both
SPE-SELECT switches are in the a or b positions, respectively.
2000 ABORT Response to the test request was not received within the allowable time period.
If the system is equipped with the High Reliability or Critical Reliability
Configuration and if the Memory circuit pack is on the standby SPE, this abort
code may indicate that the standby SPE is not responding to the handshake
message. If this is the case, the standby SPE maintenance software may take
up to two minutes to indicate that handshake communication with the standby
SPE is dow n. The ABO RT code w ill then chang e to 1339 (hand shake
communication do wn).
1. Retry the command at 1-minute intervals, a maximum of 3 times.
2315 ABORT The test was not run, because this is an extra Memory circuit pac k. No testing
is allowed for extra Memory circuit packs.
2334 ABORT The hardware mailbox on the standby Dup lication Interface board is not ready
to receive messages.
1. Retry the command at 1-minute intervals, a maximum of 5 times.
Continued on next page