Lucent Technologies Release 7

Printed in U.S.A.

Every effort was made to ensure that the information in this book was

complete and accurate at the time of printing. However, informati on is

subject to change.

Your Responsibility for Your System’s Security

Toll fraud is the unauthorized use of your telecommunications system

by an unauthorized party, for example, persons other than your com-

pany’s employees, agents, subcontractors, or persons working on your

company’s behalf. Note that there may be a risk of toll fraud associated

with your telecommunications system and, if toll fraud occurs, i t can

result in substantial additional charges for your telecommunications

You and your system manager are responsible for the security of your

system, such as programming and configuring your equipment to pre-

vent unauthorized use. The system manager is also responsible for

reading all installation, instruction, and system administration docu-

ments provided with this product in order to fully understand the fea-

tures that can introduce risk of toll fraud and the steps that can be take n

to reduce that risk. Lucent Technologies does not warrant that this

product is immune from or will prevent unauthorized use of com-

mon-carrier telecommunication services or facilities accessed through

or connected to it. Lucent Technologies will not be responsible for any

charges that result from such unauthorized use.

Lucent Technologies Fraud Intervention

If you suspect that you are being victimized by toll fraud and you need

technical support or assistance, call Technical Service Center Toll

Fraud Intervention Hotline at 1 800 643-2353 or contact your local

Lucent representative.

Federal Communications Commission Statement

Part 15: Class A Statement. This equipment has been tested and

found to comply with the limits for a Class A digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide rea-

sonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipmen t ge nerates,

uses, and can radiate radio-frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interfer-

ence to radio communications. Operation of this equipment in a resi-

dential area is likely to cause harmful interference, in which case the

user will be required to correct the interference at his own expense.

Part 68: Network Registration Number. This equipment is registered

with the FCC in accordance with Part 68 of the FCC Rules. It is id enti-

fied by FCC registration number AS593M-13283-MF-E.

Part 68: Answer-Supervision Signaling. Allowing this equipment to

be operated in a manner that does not provide proper answer-supervi-

sion signaling is in violation of Part 68 Rules. This equipment returns

answer-supervision signals to the public switched network when:

• Answered by the called station

• Answered by the attendant

• Routed to a recorded announcement that can be admini stered by

the CPE user

This equipment returns answer-supervision signals on all DID calls

forwarded back to the public switched telephone network. Permissible

exceptions are:

• A call is unanswered

• A busy tone is received

• A reorder tone is received

Canadian Department of Communications (DOC)

Interference Information

This digital apparatus does not exceed the Class A limits for radio

noise emissions set out in the radio interference regulations of the

Canadian Department of Communications.

Le Présent Appareil Nomérique n’��met pas de bruits radioélectriques

dépassant les limites applicables aux appareils numériques de la class

A préscrites dans le reglement sur le brouillage radioélectrique édicté

par le ministére des Communications du Canada.

See the preface of this document.

Ordering Information

Call: Lucent Technologies BCS Publications Center

Voice 1 800 457-1235 International Voice 317 322-6416

Fax 1 800 457-1764 International Fax 317 322-6699

Write: Lucent Technologies BCS Publications Center

2855 N. Franklin Road

Indianapolis, IN 46219

Order: Document No. 555-230-126

Comcode 108343203

Issue 4, June 1999

For additional documents, refer to the section in “About This Docu-

ment” entitled “Related Resources.”

You can be placed on a standing order list for this and other documents

you may need. Standing order will enable you to automatically receive

updated versions of individual documents or document sets, billed to

account information that you provide. For more information on stand-

ing orders, or to be put on a list to receive future issues of this docu-

ment, contact the Lucent Technologies Publications Center.

European Union Declaration of Conformity

The “CE” mark affixed to the DEFINITY® equipment described in

this book indicates that the equipment conforms to the following Euro-

pean Union (EU) Directives:

• Electromagnetic Compatibility (89/336/EEC)

• Low Voltage (73/23/EEC)

• Telecommunications Terminal Eq uipment (TTE) i-CTR3 BRI

and i-CTR4 PRI

For more information on standards compliance, contact y our local dis-

To comment on this document, return the comment card at the front of

the document or email us at document@drmail.lucent.com .

Acknowledgment

This document was prepared by Product Documentation Dev elopment,

Lucent Technologies, Denver, CO.

Contents