DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1231PGATE-PT (Packet Gateway Port)
9
Table 9-491. TEST #614 Link Status Test
Error
Code Test
Result Description/ Recommendation
1006 ABORT The port is out of service, either due to a hardware failure or the busyout port
UUCSSpp command.
1. Check if the port has been busied out. If the error log (display errors
command) contains error type 18 and the alarm log (display alarms
command) contains an active WARNING alarm for this port, the port has
been busied-out. This is a NORMAL abort.
2. If the port has not b een busied-out and ab orts with this result, execute the
Packet Gateway Port Local Loop-Around Test (#610) and the Level 1 State
Query Test (#613) via the test port UUCSSpp long command. Consult the
repair procedures for these tests.
1151 ABORT The X.25 Call Control Link has failed. It is not possible at the moment to send a
message to the Packet Gateway circuit pack to activate this test.
1. Execute the test board UUCSS command and see the repair procedures
for the X.25 Call Control Link Test (#601).
2. Repeat this test onc e the X.25 Call Control Link has been re-estab lished,
i.e., test #601 passes.
2000 ABORT Response to the test was not received from the Packet Gateway circuit pack
within the allowable time period.
1. If this same result occurs repeatedly, begin by executing the tests as
detailed in the earlier se ction. Consult the individ ual repair proced ures for
a specific test if p roblems are found.
2. If this result continues to occur, attempt to reset the circuit pack if the other
ports on the board are not in use (Yellow LED is off). Reset the circuit pack
by executing the busyout board UUCSS and reset board UUCSS
commands.
3. If this result occurs again, replace the circuit p ack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2100 ABORT The necessary system resources to execute the test could not be allocated.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL Received data test pattern does not match transmitted data test pattern. Same
recommendation as for error code 2 above.
Continued on next page