DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-312BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)]
9
There are no Test to Clear Values for the following error types. The error
types are simply provid ed as additional d ata that may prove useful while
troubleshooting.
i. This error occurs when a Layer 1 Transmission error is detected for the
port. Run the Long Test Sequence and pay p articular attention to the
results of the Layer 1 Transmission Error Counter Test (#624).
j. A BRI port supports up to three Terminal Endpoint Identifiers (TEIs). This
error occurs when the switch receives a req uest for a fourth TEI on a port.
Check the number of endp oints administered for this p ort.
k. This error occurs when an SPID initialization request is made from an
endpoint and the switc h determines that the SPID value is invalid or is a
duplicate of another SPID that is already initializ ed at Layer 3 on the port.
Check the administration of the end points.
l. This error occurs when the circuit p ack detects an ov erflow of its receive
buffers. Run the Long Test Sequence and pay par ticular attention to the
results of the Receive First In First Out (FIFO) Overflow Error Counter Test
(#625).
m. This error occurs when the BRI Port Local LAN Loop Around Test (#618)
fails. Run the Long Test Sequence and pay partic ular attention to the
results of Test #618.
n. This error most likely occurs when the Terminal Endpoint Identifier (TEI)
administered for the ASAI or Lucent end point does not match the TEI
administered in the ASAI or Lucent ad junct. Check the switch
administration of the TEI against that of the adjunc t and make sure that
both are using the same TEI.
o. Indicates that sets on the port do not support Layer 3 initialization. Consult
the Service Set documentation.