DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1660TAPE
9
563 When the MSS_RESET command was issued for a device, the TEST UNIT READY
command failed
564 When the MSS_RESET c ommand was is sued f or a de vice, the READ C APACITY com mand
failed
565 The device reset failed.
566 Device type not supported.
567 Capacity da ta is inconsistent.
568 Block size doesn’t d ivide into 8K.
601 REQUEST SENSE failed.
700 Indicates that there is no specific sense key information for a SCSI target on which a
REQUEST SENSE was issued. This should never happen because firmware only asks for
sense information if errors occurred.
701 SCSI sense information reported a recovered error on a SCSI target where it didn’t make
sense. Normally recovered errors are filtered by the HA firmware for reads and writes.
However, for other commands, this is reported to software.
702 SCSI sense information indicates that the target device cannot be accessed. This will
occur if the tape cartridge is not p resent.
703 SCSI sense information indicates t hat a SCSI command terminated with a n o nrecovered
error condition probably caused b y a flaw in the medium or an error in the recorded data.
704 SCSI sense information indicates a nonrecoverable hardware failure occurred. The tape
may be broken.
705 SCSI sense information indicates t hat there was an illegal parameter i n the command
descriptor block or in additional parameters supplied. This could be caused by a HA
firmware failure or a problem with the target device.
706 SCSI sense information indicates t hat the target device’s rem ovable medium may have
been changed or the target controller has been reset.
707 SCSI sense information indicates that reads or writes were attempted for a medium that
was protected from this operation.
708 SCSI sense information indicates that a write-once read-multiple device or a
sequential-access device encountered a blank b lock while reading or a write-once
read-multiple device encountered a nonblank block while writing. This should never
happen; the HA only supports direct access d evices.
709 SCSI sense information indicates a vendor-unique sense key.
710 SCSI sense information indicates a COPY, COMPARE, or COPY AND VERIFY com mand
was aborted due to an error condition on the source device, the destination devic e, or both.
This shouldn’t happen since these commands aren’t issued by the HA.
711 SCSI sense information indicates that the target controller aborted the command.
Table 9-624. MSS Error Actions — Continued
Code Description
Continued on next page