DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-1028MEM-BD (32MB Memory Circuit Pack)

9
Error Log Entries and Test to Clear Values
Notes:
a. This error (3) indicates that a software patc h has been applied and either the software patch is bad or was installed incorrectly.1. Back out the software patch and run the test memory UUCS long command to verify that the prob lem has been cleared .2. If the PBX system is equipped with Hig h Reliability or Critical Reliab ility opt ion (i. e. wit h dup lic ated SPEs), an d thi s erro r occ urs, a SPE interc hang e wi ll oc cur i f the h ealth of the stand by SPE p ermi ts the interchange.
Table 9-405. MEM-BD Error Log Entries
Error
Type Aux
Data Associated Test Alarm
Level On/Off
Board Test to Clear Value
01
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommend ed procedures.
0 Any Any Any test memory UUCS sh r 1
1 Memory RAM Checksum
Test (#903) MAJOR OFF test memory UUCS l r 1
3(a) Memory RAM Checksum
Test (#903) MAJOR2
2. If a spontaneous interchange has occurred (as indicated by STBY-SPE error type 103 or the
display initcauses screen), and handshake is down, (check with status spe), replace the alarmed
circuit pack on the standby SPE. If handshake is up, execute a test long clear of the alarmed
circuit pack and follow recommended procedures.
OFF test memory UUCS l r 1
101(b) none WNG OFF
150(c) none MAJOR2ON test memory UUCS l c
257 M emory Parity Checker
Test (#906) MINOR ON test memory UUCS sh r 2
513 Any(d) Memory Single Bit Errors
(#902) MINOR ON test memory UUCS l r 10
769 M emory Multiple Bit
Errors (#902) MAJOR2ON test memory UUCS l r 2
1025 Memory Error
Detection/Correction
Test (#907)
MINOR ON test memory UUCS sh r 1
1281 Memory Burst Read Test
(#908) MAJOR2ON test memory UUCS sh r 1