DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-554DISK (MSS Disk Circuit Pack)
9
■Unrecoverable hardware error on di sk
■Invalid parameter in SCSI command
■Media removed or devic e reset
■Disk is write protected
■Disk reached end of med ium
■Block reassigned on d isk
■Block reassignment on disk failed
Table 9-227. TEST #812 Disk Firmware Error
Counters Read and Clear Test
Error
Code Test
Result Description/ Recommendation
1305 ABORT Could not read firmware error counters.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1306 ABORT Could not read configuration area for defect information.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1316 ABORT Could not get access to the Mass Storage System. Other software may be
using it or background maintenance tests may be running.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, verify that the daily translation-save operation
is not in progress (issue the display system-parameters maintenance
command to display the time for scheduled maintenance and the "y/n"
option for saving translation daily).
1335 ABORT Could not run the test on the Standby SPE—Duplication not administered.
1. Refer to “STBY-SPE” .
2. Administer standby present.
1338 ABORT Could not run the test on the Standby SPE—Intercha nge pending.
1. Refer to the documentation for STBY-SPE maintenance.
2. After interchange occurs, run test on new active SPE.
1339 ABORT Could not run the test on the Standby SPE—Handshake down.
1. Refer to “STBY-SPE” .
2. When the standby is restored to service (use status spe to determine state
of standby) retry the command.
1347 ABORT Could not run the test on the Standby SPE—Refresh not complete.
1. When the standby is restored to service (use status spe to determine state
of standby) retry the command.
Continued on next page