DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-560DISK (MSS Disk Circuit Pack)

9
Disk Status Test (#815)

The Disk Status Test verifies the following:

■The Host Adapter knows about the existenc e of the Disk Drive.
■The LEDs on the faceplate can be turned on and off correctly. This verifies

only that the LED control and status logic is operating correctly. LED

operation may also be tested visua lly with test led.

■The presence of +5V and +12V
Table 9-230. TEST #815 Disk Status Test
Error
Code Test
Result Description/ Recommendation
1306
1307
1308
ABORT Internal software error between maintenance software and MSS driver.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1316 ABORT Could not g et access to the Mass Storage System. Other application software
may be using it or background maintenance tests may be running.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, verify that the daily translation-save operation
is not in progress (issue the display system-parameters maintenance
command to display the time for scheduled maintenance and the "y/n"
option for saving translation daily).
1335 ABORT Could not run the test on the Standby SPE—Duplication not administered.
1. Refer to the documentation for STBY-SPE maintenance.
2. Administer standby present.
1338 ABORT Could not run the test on the Standby SPE—Interchange pending.
1. Refer to the documentation for STBY-SPE maintenance.
2. Aft er inte rchang e occ urs, r un test o n new ac tive SPE.
1339 ABORT Could not run the test on the Standby SPE—Handshake down.
1. Refer to the documentation for STBY-SPE maintenance.
2. When the standby is restored to service (use status spe to determine state
of standby) retry the command.
1347 ABORT Could not run the test on the Standby SPE—Refresh not complete.
1. When the standby is restored to service (use status spe to determine state
of standby) retry the command.
1350 ABORT Could not run the test on the Standby SPE—Shadowing not enabled .
1. When the standby is restored to service (use status spe to determine state
of standby) retry the command.
Continued on next page