Lucent Technologies Release 7 9-1353PROCR (RISC Processor Circuit Pack) , Replac ing SPE Ci rcuit Pa cks

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-1353PROCR (RISC Processor Circuit Pack)
9
1022
1335
2500
ABORT Internal system error
1. Retry the command.
1338 ABORT The test is not allowed to run since a planned SPE interchange is in progress.
This may be caused by a planned interchange initiated automatically during
24 hour scheduled testing.
1. Wait 3 minutes and retry the command .
1339 ABORT The test could not run on the standby Processor circuit pack in the standby
SPE carrier because the standb y SPE is unavailable.
1. Refer to the STBY-SPE maintenance documentation for information on
why a standby SPE may be unavailable and what repair actions should be
taken. The screen for the status spe command should indicate that
handshake is down. This may be caused by a variety of reasons such as
the SPE-SELEC T switch es on the D UPINT cir cuit p acks b eing se t to the
position of the active SPE, a failure of the DUPINT circuit pack, or loss of
power on the standby SPE. The
SPE Select ed field on the status spe
screen will displa y
spe a or spe b if bot h SPE-SELECT swi tches a re in the
a or b positions, respectively.
2000 ABORT Response to the test request was not received within the allowable time
period. If the system is equipped with the High Reliability or Critical Reliability
Configuration and if the Processor circuit pack is on the standby SPE, this
abort code may indicate that the standby SPE is not responding to the
handshake message. If this is the case, the standby SPE maintenance
software may take up to two minutes to indicate that handshake
communication with the standby SPE is down. The ABORT code will then
change to 1339 (standby SPE unavailable).
1. Retry the command at 1-minute intervals, a maximum of 3 times.
2334 ABORT The hardware mail on the stand by Duplication Interfac e board is not ready to
receive messages.
1. Retry the command at 1-minute intervals, a maximum of 5 times.
FAIL The Processor Write Buffer is not operating correctly.
1. Replace the Processor circuit pack immediately. To replace the Processor
circuit pack, refer to
Replac ing SPE Ci rcuit Pa cks in Chapter 5.
PASS The Write Buffer portion of the Processor c i rcuit pack is operati ng correctly.
Table 9-532. TEST #900 Processor Write Buffer Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page