Lucent Technologies Release 7 Read and Clear Board Counters (#887)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-1268PKT-INT (Packet Interface Circuit Pack)
9
Read and Clear Board Counters (#887)
This test involves sending command s to read on-circuit p ack error counters on
the Packet Interface circu it pack. It also verifies the message interface between
the SPE and the Packet Interface circuit pac k.
This test checks different circuit p ack counters dep ending on whether the circu it
pack is on the active or sta ndby SPE.
If the Packet Interface circ uit pack is on the acti ve SPE, this test reads and clears
the Parity Error counter and FIFO Overflow counter. Those counters are not used
when a Packet Interface circui t pack is in standb y mode.
If the Packet Interface circuit p ack is on the standby SPE, this test reads but d oes
not clear a Translation RAM counter. The Translation RAM counter is not cleared
1-3 FAIL The test failed. Maintenance was unable to establish a looparound link from
the Packet Interface circuit pack back to itself or was unable to receive d ata
that was sent out over one side of the looparound link.
1. Issue the test packet-interface CS command to retry the test. If the same
error code is observed, background maintenance software will
automatically attempt to reset the circuit pack and clear the problem.
2. Retry the command and if the test fails, replace the circuit pac k.
3. If the test continues to fail after replacing the circuit pack, run the test
packet P long command. If any of the tests fail, the fault may be on the
Packet Bus. Refer to the PKT-BUS (Packet Bus) Maintenance
documentation for recommended repair procedures.
4. If the test continues to fail after the circuit pack is replaced and with no
other alarms associated with the Packet Bus or circuit packs connected to
the Packet Bus, follow normal escalation procedures.
PASS This test passed. The circuit pack and its interface with the SPE are
functioning properly. If the system is unable to place calls on cabinets other
than the SPE cabinet, then:
1. Check for errors on the Packet Bus and Maintenance/Test circuit pack.
Solve those errors first.
2. Check all other circuit packs connec ted to the Packet Bus in the same
cabinet. Packet Bus failures are likely to be caused by a faulty circuit pack
connected to the backplane or b ent p ins on the back plane.
3. Check the Packet Interface circuit pack c onnections to the Packet Bus.
Table 9-500. TEST #886 Maintenance Looparound Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page