DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-559DISK (MSS Disk Circuit Pack)
9
2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
5102 ABORT Could not allocate the Mass Storage System to run this test
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, verify that the daily translation-save
operation is not in progress (issue the display system-parameters
maintenance command to display the time for scheduled maintenance
and the "y/n" option for saving translation daily).
NO
BOARD The disk has been placed in the "uninstalled" state.
1. Verify that the disk drive is fully inserted and powered up.
2. Attempt a demand reset of the disk.
1FAIL The Disk loop-around test failed.
1. Retry the command a maximum of 5 times.
2. If the command continues to fail, replace the Disk circuit pack, issue the
reset disk command and perform the restore disk command. This will
take up to 1 hour for a complete restore.
3. If the test continues to fail, replace the MSSNET circuit pack.
PASS The Disk loop-around test pa ssed. Look at the results of other tests to see if it
is operating correctly.
1. See the MSS Error Actions Table at the end of the TAPE section.
Table 9-229. TEST #814 Disk Loop-Around Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page