DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1089MODEM-PT (Modem Pool Port)
9
4000 ABORT System resources needed to c omplete the test could not be allocated.
Ordinarily, this means the c onversion resource or other hard ware used during
the test was in use.
1. Wait 1 minute and attempt the test again.
2. If the same error occurs, use the status port command to determine
whether the Modem Pool conversion resource is in use.
3. If the conversion resource is in use, and it is absolutely necessary to test it,
the call must be dropped by issuing a busyout port UUCSS command
against the conversion resource. Run the test again.
4. If the same error occurs while the conversion resource is idle, busyout both
Modem Pool conversion resources on the TN758 Pooled Modem circuit
pack containing the conversion resource under test. Run the test again.
5. If the test continues to abort, replace the Pooled Modem circuit p ack and
retest.
6551
5ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. Issue the test port long command on the port on which the test aborted. If
any test aborted or failed, follow recommended maintenance strategy for the
appropriate port type (for example, ANL-LINE, DIG-LINE).
None FAIL The test failed. This error is internal to the Pooled Modem circuit pac k and does
not involve external equipment or interfaces.
1. Busy-out both of the TN758 Pooled Modem conversion resources on the
circuit pac k containing the failing conversion resource.
2. If the test continues to fail, replace the Pooled Modem circuit pack and
retest.
Any FAIL The Network Processing Element (NPE) of the tested port did not conference the
tones correctly. This will cause noisy and unreliable connections.
1. If the remaining ports are currently not in use (the yellow LED is off), reset the
circuit pack and repeat the test.
2. If the test fails again, replace the circuit pack .
PASS The port can correctly conference multiple connections. User-rep orted troubles
on this port should be investigated using other port tests and by examining
station, trunk, or external wiring.
Table 9-432. TEST #97 Modem Pool Conference Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page