DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1772TIE-TRK (Analog Tie Trunk)
9
These tests are run by the Automatic Transmission Measurement System (ATMS).
They are not part of the long or short trunk test seq uences. Instead, they are run
on demand with the test analog-testcall command or as p art of ATMS
scheduled testing. For more information, see ‘‘Automatic Transmission
Measurement System (ATMS)’’ in Chapter 6.
The test call is run from an analog port on a TN771 Maintenance/Test circuit
pack. It attempts to seize a p ort and make a call to a ter minating test line (TTL)
on the trunk’s far end. Transmission performance measurements are mad e and
compared to adm inistered thresholds. Errors are generated when results fall
outside of ‘‘marginal’’ or ‘‘unacc eptable’’ thresholds. Detail and summary
measurement reports are obtainab le via the list testcalls command.
Table 9-665. TEST #844-848 Transmission Test
Error
Code Test
Result Description/ Recommendation
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use display port UUCSSpp to determine the trunk group/member number
of the port. Use the "status trunk" command to determine the service state of
the port. If the service state indicates that the port is in use, then the port
unavailable for this test. (Refer to section on "status" commands for a full
description all possible states). You must wait until the port is idle before
retesting.
2. If the port status is idle, then retry the command at 1-minute intervals for a
maximum of 5 retries.
1001 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
1002 ABORT The system could not allocate timeslots for the test. The system may be under
heavy traffic conditions or it may have timeslots out of service due to TDM bus
errors.
1. If system has no TDM bus errors and is not handling heavy traffic, repeat
test at 1-minute intervals for a maximum of 5 retries.
1004 ABORT The port has been seized by a user for a valid call. Use status trunk to determine
when the port is availab le for testing.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
1005 ABORT Trunk has been administered as incoming-only; transmission tests can only be
run on outgoing trunks.
1115 ABORT The near end test line on the TN771 circuit pack could not be allocated.
1. Verify that the TN771 circuit pack is in service and that port 1 is administered
and in service with the status port command.
2. Retry the command at 1-minute intervals for a maximum of 5 retries.
Continued on next page