DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-548DISK (MSS Disk Circuit Pack)
9
2000 ABORT Response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
5102 ABORT Could not allocate the Mass Storage System to run test
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, verify that the daily translation-save operation
is not in progress (use the display system-parameters maintenance
command to display the time for scheduled maintenance and the "y/n"
option for saving translation daily).
NO
BOARD The disk has been placed in the "uninstalled" state.
1. Verify that the disk drive is fully inserted and powered up.
2. Attempt a demand reset of the disk.
5513 FAIL The system contains 3 memory boards but the capacity of the disk is not large
enough for the coredump file.
1. Issue the list configuration control command and check if the carrier is
equipped with 3 memory boards and the vintage of the TN1657 Disk
circuit pac k is less than Vintage 4.
2. Replace the Disk circuit pack with one of Vintage 4 or greater, issue the
reset disk command, and perform the restore disk command. The
restore operation may take up to 1 hour to complete.
5514 FAIL The system contains 3 memory boards but the disk has not been configured
for a large coredump file. The tape and disk should have been c onfigured for
the larger memory size as part of the procedures for installing 3 memory circuit
packs.
1. Issue the configure tape 3-mem command to ensure that the file system
on the tape is configured for the large core dump file. This command
cannot execute if the tape is already configured.
2. Issue the restore disk command. This step may take up to 1 hour for a
complete restore.
3. Execute the test disk command to clear the alarm.
Table 9-224. TEST #809 Disk Reset Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page