DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-551DISK (MSS Disk Circuit Pack)

9
Disk Audit Test (#811)

The Disk Audit Test verifies the following Disk Medium condi tions.

■The directory can be read.
■There are no "dirty" files. What is meant by "dirty" is that the data in the file

may not be complete or the d irectory entry was never up dated after the

data was written to the device

2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
5102 ABORT Could not allocate the Mass Storage System to run this test
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test co ntinues to abort, verify t hat the daily translation-sav e operation
is not in progress (issue the display system-parameters maintenance
command to display the time for scheduled maintenance and the "y/n"
option for saving translation daily).
NO
BOARD The disk has been placed in the "uninstalled" state.
1. Verify that the disk drive is fully inserted and powered up.
2. Attempt a demand reset of the disk.
1FAIL The disk could not be accessed, the chec ksum on the data written did not
match the checksum in memory or the data read did not match the data
written.
1. Retry the command for a maximum of 5 retries.
2. If the command continues to fail, replace the Disk circuit pac k, issue the
reset disk command and perform the restore disk command. This will
take up to 1 hour for a complete restore.
3. If the test continues to fail, replace the MSSNET circuit pack.
PASS The Disk write read test executed successfully. Look at the results of other
tests to see if it is operating correctly.
1. See the MSS Error Actions Table at the end of the TAPE section.
Table 9-225. TEST #810 Disk Write-Read Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page