DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-317BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)]
9
1139 ABORT The Packet Bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. After completing Step 1, execute the test port long PCSSpp command,
and review the results of the BRI Port Local LAN Loop Around Test to
verify the repair.
1141 ABORT The PKT-CTRL is out-of-service.
1. Follow the repair procedures for the PKT-CTRL.
2. After completing Step 1, execute the test port long PCSSpp command,
and review the results of the BRI Port Local LAN Loop Around Test to
verify the repair.
1144 ABORT The PPN Packet Bus is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. After completing Step 1, execute the test port long PCSSpp command,
and review the results of the BRI Port Local LAN Loop Around Test to
verify the repair.
2012 ABORT Internal System Error.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
FAIL The Loop Around Test has failed.
1. If the test fails repeatedly, attempt to reset the circuit pack if the other
ports on the board are not in use. Reset the circuit pack by issuing the
busyout board PCSS and the reset board PCSS commands.
2. If the test fails again, execute test port-network
<pn#>
. If this fails,
follow failure procedures in ‘‘PKT-BUS (Packet Bus)’’ section.
3. If tests executed in Step 2 pass, the problem is local to the BRI board.
Replace the circuit pack.
PASS The BRI Port Local LAN Loop Around Test has passe d .
Table 9-140. Test #618 BRI Port Local LAN Loop Around — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page