DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-141ASAI-PT
9
The Deactivated state indic ates a problem with the ASAI circuit p ack. When in
this state, the Level 1 interface is idl e and is not trying to c ommunicate with the
BRI endpoints or adjunct . When an ASAI port is placed in the o ut-of-service
state, Level 1 is also put into the deac tivated state. This could b e due either to
the system detecting a fa ult with the port or in response to a busyout port
UUCSSpp request.
Table 9-56. TEST #621 Level 1 Status Inquiry
Error
Code Test
Result Description/Recommendation
1187 ABORT The board, port, or statio n may have been busied -out by a technic ian.
1. Look in the Error Log for Error Type 18 (port busied out) for this port and
ASAI-BD (board busied out). If this error type is present for ASAI-PT
only, then release the port using the release port pp command and run
the test again. If the error is present for both ASAI-BD and ASAI-PT , then
release the board with the release port UUCSS c ommand and run the
test again.
NOTE:
When you release a port, you release all p orts associated w i th it. If
certain ports stil l need to be busied out, use the release port
UUCSSpp command to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals for a maximum of 5 times.
2000 ABORT Response was not received from the circuit pack within the allowable time
period.
1. If the test aborts repeatedly a maximum of 5 times, reset the circuit pack
using the busyout board UUCSS and reset board UUCSS commands.
2. If the test aborts again, replace the circuit p ack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
Continued on next page