Lucent Technologies Release 7 9-1098M/T-ANL (Maintenance/Test Analog Port)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-1098M/T-ANL (Maintenance/Test Analog Port)
9
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out of service due to TDM-BUS
errors. A system is considered under heavy traffic when the Call Processing
Occupancy is greater than 50% or when the System Management and the Call
Processing Occupancies together exceed 65%. To view the system
occupancy measurements enter the command status system health on the
system technician terminal.
1. If system has no TDM-BUS errors and is not handling heavy traffic, repeat
test at 1-minute intervals a maximum of 3 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of tone detectors present or some tone detectors may
be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals a maximum of
3 times.
1004 ABORT The port has been seized by a valid ATMS test call.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2. If the test continues to abort and the port is not in use on a valid ATMS Test
Call, escalate the problem. To determine whether the port is in use by an
ATMS Test Call enter status station ext where ext is the assigned ATMS
station number.
2000 ABORT Response to the tes t re quest was not re ceived within the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 3 times.
Any FAIL The NPE of the tested port was found to be transmitting in error. This will cause
noisy and unreliable connections.
1. If the remaining ports are currently not in use (yellow LED is off), try to reset
the circuit pack via the busyout board UUCSS, reset board UUCSS,
release board UUCSS command sequence. Then repeat the test.
2. If the test fails again, replace circuit pac k.
PASS The port is correctly using its allocated time slots. User-reported troub les on
this port should be investigated by examining station, trunk, or external wiring.
Table 9-436. TEST #9 NPE Cross Talk Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page