DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-208ATM-EI (Expansion Interface Circuit Pack)

9
ATM Board Reset (#1256)

This test is destructive. If the ATM-EI board is in the PPN or is a standby in the

EPN, the reset is done through the SAKI reset interface. If the ATM-EI is an

Expansion Arch Angel (act ive ATM-EI board in the EPN) a special message is

sent to the board over the EAL if the EAL is present.

Table 9-88. ATM Board Time Of Day Update (#1261)
Error
Code Test
Result Description/ Recommendation
2031 FAIL The attempt to send the message to the ATM-EI circuit pack was not
successful.
2500 FAIL Did not send the time of day information to the board.
1. Retry the command at 1-minute intervals a maximum of 3 times.
PASS The ATM-EI circuit pack is successfully updated with system time.
1. If the status port-network command still ind icates that this link is d own,
it is possible that one or both of the ATM-EI circuit packs have been
busied out.
2. If the link still does not come up, reset one or both ATM-EI circuit packs
on the link.
0NO
BOARD No board detected.
1. Resolve either wrong board (Error 125) or no board (Error 131) issues, if
applicable.
2. Check that the board is properly translated and inserted. If so, check for
hyperactivity (Error 1538). If hyperactive, use the reset board UUCSS
command.
3. Run the test again. If it fails, the NCE chip on the circuit pack may be
bad. Replace the pack and retest.
Continued on next page
Table 9-89. ATM Board Reset (#1256)
Error
Code Test
Result Description/ Recommendation
1386 ABORT No Active EAL to the board. This error applies only if the board under test is
in EPN. Check the error logs for SYS-LINK errors against the port network in
which the ATM-EI is residing and take appropriate diagnostic action for the
SYS-LINK.
Continued on next page