DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-733DUPINT (Duplication Interface Circuit Pack)
9
active and standb y SPE carriers. Then, if all DUPINT and DUP-CHL alarms are
retire d, a r eleas e of th e stan dby SPE w ill al low me mory s had owing to be turn ed
back on (if no further alarms p ertinent to memory shadowing are present) and
refres h to c ompl ete. Se e STBY-SPE fo r more deta ils as to how the tu rning on/o ff
of shadowing is controlled .
Error Log Entries and Test to Clear Values
Notes:
a. Indicates either a failure durin g a reset of the Duplication Interfac e circuit
pack, or a report that either or b oth of the HFAIL and STDONE bits are in
the wrong state. These errors cause a MINOR alarm that does not affec t
memory shadowing. The Aux Data indi cates which error occur red.
Table 9-281. Duplication Interface Circuit Pack Error Log Entries
Error
Type Aux
Data Associated Test Alarm
Level1
1. DUPINT alarms can be resolved only when the alarmed Duplication Interface circuit pack is in the
activ e SPE car rier.
On/Off
Board Test to Clear
Value
0 0 Any Any Any
1 Control Register test (#865) MAJOR ON test dupl l
257 Any Mailbox Loop-around test (#866) MAJOR ON test du p l l
513 Any Local Loop-around test (#867) MAJOR ON test du p l l
769 Any Memory Shadowing Bounds Test
(#868) MAJOR ON test dup l l
2049 (a) Any Ac tive DUPINT Reset Test (#870)
Active DUPINT STDONE/ HF AIL Check
Test (#979)
MINOR ON test dupl l
3073 (b) 2 None MINOR ON test dupl l c
3329 (c) Any None MAJOR ON test dupl l c
Aux
Data Cause of Error
None The active DUPINT Reset Test failed because the reset was
unsuccessful.
1 The STDONE bit is in the wrong state.
2 The HFAIL bit is in the wrong state.
3 The STDONE and HFAIL bits are both in the wrong state.